VERIFICATION EXAMPLES FOR SCADA Pro

Software Verification Examples for SCADA Pro 30 A4. Static Analysis of Plate Structures under Inplane Loading (Discs) A4.1. Wall Problem Description A two dimensional disk, subjected to coplanar loading is examined (Figure A4.1.1). Geometry, Properties and Loads The plate of dimension 10mx5m has 20cm thickness and is subjected to an inplane concentrated load of 50kN. Modulus of Elasticity is 29GPa and Poisson ratio ν=0.20. Plate is fixed along its smaller sides and free along the others. (800 Shell Finite Elements) Figure A4.1.1. Disk under inplane loading. Assumptions During analysis, theory of discs (plates under inplane loading) has been adopted. Technical Features in ScadaPro Tested  Plate elements under inplane loading  Fixed boundary conditions Results Comparison Maximum values of inplane displacements along load direction obtained from ScadaPro analysis and stresses at point B (Figure 4.1) are presented in Table A4.1.1 and A4.1.2 respectively and are compared with those obtained from Sap2000 and Abaqus software. Moreover, in Figures A4.1.2- A4.1.3 contourlines of stresses σxx and σyy are presented.