MODEL CHECKS & SIZING MESSAGES

SCADA Pro - Controls & Messages 7 so the total thickness should be less than the sum of the upper and lower parts. Correcting this thickness eliminates the message. warning4001 Member (1) has release of all principle-end moments and warns the user about members with this condition. warning4002 Check the degrees of freedom of the members coinciding in node (11031)(2). In this node all the members that coincide have the above condition and this node does not belongs to a surface node Error4008 State 7 of Column 1 has a zero value in some dimension error4114 When finite surface elements on elastic ground (OEF) are defined and the spring constant is not defined, an error message is displayed for the surface nodes. GEOMETRIC REQUIREMENTS CONTROL MESSAGES BEAMS: EX: • Beam 31: The ratio of the beam span l to the cross-sectional height hw is less than 4 (l/h=2.74). The beam is considered to be high-topped. (ECOS 18.3.1(b)) • Beam 31 - Node 52 end: the eccentricity of the beam axis with respect to the column's C.B. (e=0.20m) is greater than bc/3 ( bc=0 .18m) (EKOS 18.3.1(c)) • Beam 31: The width of the beam ( bw = 0.65m) is greater than min( 2∙bc , bc + hc/2 )= 0.43m. (ECOS 18.3.1(a)) • Beam 31: The width of the beam ( bw = 0.12m) is less than 200mm. EC8 - CPM: • Beam 31 - Node 52 end: the eccentricity of the beam axis with respect to the column's C.B. (e=0.20m) is greater than bc/4 ( bc=0 .15m) (EC8-1, 5.4.1.1.2.1(2))