MODEL CHECKS & SIZING MESSAGES

SCADA Pro - Controls & Messages 6 Error1009 This message appears when the degrees of freedom of a node are manually configured beyond the usual cases (all tucked, all free, elastic supports, etc.). It is a warning and is intended to prevent a possible error. Error1017 This end of the member is not connected to any other member of the carrier. If it is inserted as a furrow, the message is ignored, otherwise it must be examined because it is not connected to either another beam or post. Error1017 This end of the member is not connected to any other member of the carrier. If it is inserted as a furrow, the message is ignored, otherwise it must be examined because it is not connected to either another beam or post. Error1007 The start node and the end node of Truss members shall not depend on a baffle node. They shall detach from the baffle node. error2006 One of the elements (beams, lines, etc.) that define the contour - boundaries of the plate has a problem, i.e. it may have been erased afterwards or not inserted correctly from the beginning. Error2001 The numbering of the plates must be unique per level. By commanding either automatic or manual renumbering the problem is solved. Error2002 The slab was automatically identified initially but its name includes an English question mark (?) which means that it needs the modelling process. The message therefore appears when this modelling has not been done. Error2003 It must be done, using the corresponding command, Side Match for the specific plate. Error2003 It must be done, using the corresponding command, Side Match for the specific plate. error2004 In addition to the obvious message above, the plaque symbol is coloured red. Eliminating the message and the red colour can be done either by using the automatic thickness calculation command, or by manually entering a desired thickness. error2005 The message is about Zoellner plates where there are 3 thicknesses in introduction. The thickness of the upper plate the thickness of the lower plate (which can be 0) and the total thickness including the two previous thicknesses and the intermediate thickness with the gaps. It cannot