MODEL CHECKS & SIZING MESSAGES

SCADA Pro - Controls & Messages 5 error1021 The physical cross-section of the post in which the petal was placed has a problem (probably it was erased afterwards without erasing the petal or the correct insertion was not done from the beginning) error1022 When a pedicle is inserted into a natural post cross-section, this cross- section is internally connected to the pedicle. When this connection for some reason is not made correctly in the first place or is subsequently lost, there is a problem and the penetrate must be deleted and reinserted. error1024 New control warning message when for a member, the value of the elasticity modulus has been given less than the value of the shear modulus. error1301 By definition, the columns are considered the only vertical elements and the beams all the rest. So when the above message appears, it means either that a beam cross-section was initially selected by mistake when inserting a column, or that the beam was subsequently rotated and came to a vertical position. In the first case the member must deleted and re-inserted, while in the second case there is no problem. error1301 This particular member of the post has large rigid sections at its ends, the remaining elastic length is very short. Error1023 All the elements of the operator when they are imported are assigned to one of the levels of the building. This message means that the start node and/or the end node of the pole do not belong to any of the levels defined, i.e. the elevation of these nodes is not the same as any of the station elevations, nor does it belong to the +/- range of elevations. The problem is addressed by examining the nodes on a case-by-case basis. Error1023 All the elements of the operator when they are imported are assigned to one of the levels of the building. This message means that the start node and/or the end node of the beam do not belong to any of the levels defined, i.e. the elevation of these nodes is not the same as any of the station elevations, nor does it belong to the +/- range of elevations. The problem is addressed by examining the nodes on a case- by-case basis. error1049 Warning message when surface elements have been placed at level 0 and are not defined as surface elements on elastic ground.