MODEL CHECKS & SIZING MESSAGES

SCADA Pro - Controls & Messages 4 Error1012 The message is about a node that has a problem (has been deleted or did not exist in the first place) Error1013 The correct degrees of freedom of the pediment's origin node are P(edge) - E(edge) - P(edge) - E(edge) - E(edge) - P(edge) - E(edge) - E(edge). The message appears when one or more degrees of freedom is something other than the above. Error1014 The correct degrees of freedom of the end node of the pediment are P(edge) - E(free) - P(edge) - E(free) - P(edge) - E(free) - P(edge) - E(free). The message appears when one or more degrees of freedom is something other than the above. Error1015 The specific property or properties of the beam is wrong. By displaying the properties, the incorrect property can be identified. Error1016 The specific property or properties of the pole is wrong. By referring to the properties, the incorrect property can be identified. Error1017 This end of the beam is not connected to any other member of the carrier. If it has been inserted as a furrow the message is ignored, otherwise it must be examined because it is not connected to either another beam or a post. Error1017 This message means that the beam as a physical cross-section is not connected to a column but its mathematical member is connected to another mathematical member as in the case of indirect support. So it is not an error in this case but in general it should be checked on a case by case basis. Error1018 The beam is not connected either at the beginning or at the end with other linear members of the beam. It must be considered on a case-by- case basis because it is wrong to be completely unconnected but there is also the possibility that it is connected at surface nodes. Error1019 The post is not connected either at the beginning or at the end with other linear members of the carrier. The message must be considered on a case-by-case basis because it is wrong to be completely disconnected but there is also the possibility that it is connected to surface nodes. Error1020 The correct degrees of freedom of the node of the pediment are P(edge) - E(greedy) - P(edge) - E(greedy) - P(edge) - E(greedy) - E(greedy). The message appears when one or more degrees of freedom is something other than the above.