MODEL CHECKS & SIZING MESSAGES

SCADA Pro - Controls & Messages 3 deleted. The model calculation as well as its update automatically deletes these disconnected nodes. Error1003 It means that the beam starts and ends at the same node. This is wrong and the beam should be deleted and reinserted. Error1003 The start and/or end node does not exist (may have been deleted). The member must be re-entered. Error1003 The message appears when the beam member is below 10 cm. It is advisable to avoid such members in the carrier. Error1004 The message appears when the pole member is below 10 cm. It is advisable to avoid such members in the carrier. Error1004 It means that the pole starts and ends at the same node. This is wrong and the pole should be deleted and reinserted. Error1005 There are members with the same number. The renumber members command must be used to correct the problem. Error1006 The two members have the same start and end node. It is not necessarily wrong because it is possible that there are elements (e.g. beams) at the ends of two opposite walls. But it is also possible that the same member has been inserted twice by mistake. Error1007 There are members with the same number. The renumber members command must be used to correct the problem. Error1007 The two nodes coincide which can happen in the case of e.g. a perfectly symmetric building where the diaphragm node can coincide with a column node. In general, however, it is wrong and must be considered on a case-by-case basis Error1008 The message is about a node that depends on a buffer node that has a problem (has been deleted or did not exist in the first place) Error1009 The message is about a node that has a problem (has been deleted or did not exist in the first place) error1010 The message is about a node that has a problem (has been deleted or did not exist in the first place) Error1011 The message is about a node that has a problem (has been deleted or did not exist in the first place)