B. COLUMN REINFORCEMENT DETAILS

45 CHAPTER B: COLUMN REINFORCEMENT DETAILS In the summary results the values according to the modified reinforcements are updated and indicated Let's look at each case in detail: 1. To test whether your cross-section with the table data is satisfied when checking in tension: . select the . see the results of the checks in the white box You also perform tests by changing either the diameter φ, or the distance s or the number of segments in the table and by clicking on Run tests to see the results. Remember after you have concluded, go to the Connectors field and make the modifications to update both the project and the issue. 2. To calculate the distance of fasteners for a specific diameter: . Write the diameter . you set a maximum distance from which the program will start checking . select the command and the program completes the column s with the calculated distances If you check the checkbox then, when calculating the distances that satisfy the checks, the programme shall also take into account the maximum distances in the Regulation.