B. COLUMN REINFORCEMENT DETAILS

29 CHAPTER B: COLUMN REINFORCEMENT DETAILS • You now have the possibility to numerically enter or change the number connector sections in the columns. (If you delete a connector, make sure that you also update the number of segments in the corresponding field.) The program automatically calculates and displays the segments of the installed fastener. However, it is possible to set the number of segments you wish, a feature particularly useful for valuations of existing buildings. OBSERVATION: The program in the selection of fasteners in the dimensioning of the poles, taking into account the homomorphism, means that, in a cross-section all fasteners will have the same diameter and the same distances between them. So when making modifications to the fasteners, it is recommended that you take care of homomorphism. Otherwise, in the subsequent rechecks, the program itself will take into account the most unfavourable connector per region and homomorphize with it. However, you have the possibility to have different connectors per area (branch), e.g. a cross- section C. The program arms the two branches itself. If you wish, you can intervene in the Controls field (see &9) in the table to change the connectors and re-check. Then return to the Connectors field and make the modifications to update both the drawing and the prints. Horizontal wall frame reinforcement In the new version of SCADA Pro, the possibility of inserting, designing and modifying the horizontal reinforcement of the trusses in the walls has been added. Regarding the modification of the horizontal reinforcement, a new field was added to the editor in the "Connectors - Gratings" section to change it.