A. DETAILS OF BEAM REINFORCEMENT

CHAPTER A : 'DETAILS OF BEAM REINFORCEMENT' 34 props. The logic of the program is that the main (initial) iron of the opening is always taken into account in the supports. So in the case where, for example, there are 4F14 in the opening below and 2F14 in the supports below, now the beam reinforcement details you can place 2Φ14 bottom opening reinforcement (which also reaches the supports) and the remaining 2Φ14 of the opening can placed as additional reinforcement in the opening. This placement is done from the "Add-ons" option. where you specify the number and diameter of the additional The bars are designed from the centre of the beam on both sides and therefore it is mandatory to give both lengths l1 which determine whether these bars will be taken into account in the supports. In particular, if each of these lengths is equal to or greater than half the net length of the beam, they are taken into account in the supports, otherwise they are taken into account only in the span.