8B. ANALYSIS PART 2

CHAPTER 8B 'ANALYSIS' 73 OBSERVATIONS : The direction is disabled which means you cannot select it. However, the ratios are calculated internally for each direction and the highest one is taken into account and displayed (as in the corresponding printout) For performance level A you will not see a reason as a result. You will see either the value 0 (green) or the value 1 (red). This is because, as is well known, failure at A means a non-zero value of the rotation angle of the plastic joint. As for the cutting capacity check, here too you do not have reasons but two values, the value 0 (green) which means that for the given level of performance the cutting capacity has not exceeded any of the strengths according to CAN.EPE and the value 1 (red) which means that one of the reasons is greater than one.