8A. ANALYSIS Part 1: NEW BUILDINGS

CHAPTER 8A 'ANALYSIS' 8 Where you can enter the values of the multipliers for inertias of the linear structural elements to be considered in the analysis. OBSERVATIONS: By default, all multipliers are automatically set to the value specified in the corresponding regulation. Especially for a static inelastic analysis scenario, whether it is Eurocode 8 or CANPE (EC- 8_Greek / Inelastic), the multipliers of the inertial quantities defined here will be taken into account in the first Pushover analysis concerning the permanent and mobile loads with default values those provided by EC8. Then, in the parameters of the inelastic analysis, you have the possibility to specify whether these values will be maintained in units, at all stages of the process, or whether they will be reduced at each step starting of course from the whole initial values. The impairment can be done either from the beginning at each step, or after the plastic joint has been created. Also, here you can set the aspect ratio for the vertical elements in order for them to be marked as "Valley". Select to update the script and register the changes.