7. LOADS

CHAPTER 7 "CARGOES" 14 Selecting the "Clean Selectivelybutton deletes only the load you have selected in the table of plate loads. The logic and way of using the command is the same as that of the "Clear" command. The choice of the "Undo" button undoes the cleanup, either total or selective. It was mentioned earlier that using the "Clear" and "Clear Selectively" commands defines loads to be deleted by entering the "Delete" designation in the "Status" column. The 'Undo' command deletes the 'Delete' designation, in effect undoing the process of deleting the loads. Finally, selecting the "Exitbutton closes the dialog box and you are returned to the interface. OBSERVATION : If you select the "Exit" button without first pressing the "Apply" button, all the changes you have made will not be taken into account. 2.3 Leakage lines The calculation of the loading surfaces resulting from the geometric division of the floor plan surface, which are then used to calculate the design actions of the beams (surfaces whose loads will be applied to the beams), The calculation is done automatically by the program according to the support conditions, either Overall per level, by simply selecting the command, or Selectively , by selecting the slabs one by one. OBSERVATIONS : The calculation of the Leakage Lines is for rectangular shaped plates or with rectangular modelling. The calculation of the Leakage Lines depends on the support conditions. The calculation of Leakage Lines is applied to conventional slabs and not to slabs with finite surface.