6. SLABS

CHAPTER 6 "SLABS" 9 In the "Type" field you select whether the blank slab will be one or two Addresses (one or two-way or four-way). Then you define the widths of the solid belts. Enter the width in the corresponding field and press the button. Select the side (beam side) on which the solid zone boundary will be placed parallel to the previously defined width. Show one beam per direction (and not all if there is more than one). Draw the line (boundary of the compact zone) and finally select with the mouse the half-plane of its definition. The procedure is repeated for the remaining solid zones. OBSERVATIONS: Show one beam per direction (not all if there is more than one). Solid bands shall be given continuously and circularly, clockwise or anticlockwise. If you press the right mouse button (cancel) between the definitions of 2 adjacent zones, the dialog box for defining the plate with spaces appears again, so you set a different width for the next zone you enter.