6. SLABS

CHAPTER 6 "SLABS" 5 IMPORTANT OBSERVATIONS: In the initial recognition of the slab, the program takes into account the value for the Minimum slab thickness given in the "Parameters", calculates the required one (based on E.K.O.S. ) and by comparing the two values, keeps the maximum one. In case the design is based on EURODATA , then the Final Thickness of the slab will be obtained after the Deformation Check , but it cannot be proposed in the initial identification of the slab because its calculation requires its reinforcements. 1.2 Retrieved from In SCADA Pro the import of the plates is done in 2 ways. Either automatically, (in total on the whole active floor or selectively), or by user-defined membership. OBSERVATION: The selection of the country in the General Parameters when starting a new study determines the choice of the type of slab to be inserted during the "Find"