6. SLABS

CHAPTER 6 "SLABS" 28 Checks The Checks command should always be run to avoid possible errors. OBSERVATION: However, to avoid notifications regarding plate reactions, it is better to first run the plate load found in the next section " Loads">>"Plate Loads " and then check the checks. Select the checks command. Opens a .txt file that informs the user of the results of the general plate checks for each level. If the file is blank, it means there are no errors. Otherwise, before proceeding to "Loads" correct all the errors in the plates. RESULTS OF GENERAL INSPECTIONS OF PLANKS error2006 There is a problem on the plate (%-d, %-d)\n Error2001 There are plates with the same numbering (%-d)\n Error2002 No modeling has been done on the Plate (%-d)\n Error2003 The sides of the plate are not correctly assigned (%-d)\n Error2003 The sides of the plate (%-d)\n are not correctly assigned error2004 Plate thickness less than min (looseness check) (%-d)\n Error2005 Plate thickness less than the sum of Upper thickness + Lower thickness (%-d)\n Error3001 There may be a load with the wrong sign (%-s=%-.2f) warning3002 State %-d has no plate reactions loads\n Error3003 Plate %-d