5. TOOLS

CHAPTER 5 "TOOLS" 7 Select the command and then the beams 1 and 2. When creating the mathematical model, the node of the indirect support will be created at position A. EXAMPLE 2 Purpose : to create indirect T-form support. Draw beams 1 and 2. Select the command and show beams 1 and 2 in sequence. The order does not matter. Then and by creating the mathematical model, the node of the indirect support will be created at position A and beam D2 will be cut into two sections 2a and 2b. EXAMPLE 3 Purpose : creation of indirect T-formsupport Draw beams 1 and 2 so that beam 1 ends up to the centreline of beam 2. Select the command and point to beams 1 and 2 in sequence. The order is not important. You will then notice that a distance is created between beams 1 and 2. Then use the command again and again point to beams 1 and 2. Then and by creating the mathematical model, the node of the indirect support will be created at position A and beam 2 will be cut into two sections 2a and 2b. EXAMPLE 4