5. TOOLS

CHAPTER 5 "TOOLS" 33 In order to select the type for which the corresponding resistance moment will be calculated, the program now classifies the cross-section in the data input and the corresponding relation is selected accordingly. OBSERVATION: However, for cross-sections of category 4, it was not possible to calculate the required Weff,min size in the data input, so the check for these cross-sections is not performed and a corresponding information message is displayed. Let's take a closer look at the use of the command: The command can be executed either per level in 2D or for all nodes that "look" in 3D. PREREQUISITE: Nodes should be "visible", because, as is well known, nodes that are not embedded in a floor are not shown. So for them, the specification will not be done, either in 2D or in 3D. So when the command is executed, the results are displayed at the bottom