BASICS

CHAPTER 1 "BASICS" 5 Diameter : Graphics: Set a point on the desktop that will be the centre of the circle and a second point to set the diameter, With the coordinates: Set the first point on the desktop and select the command or to specify the end point of the circle diameter. 1.3 Arc Command to draw arcs . The definition of the arc can be done in one of the following two ways (like the " Circle " counterparts) see "Circle"> Centre, Radius see " Circle"> Three Points 1.4 Polygon Command to draw inscribed or circumscribed polygons with a specified number of sides in a circle of a specified radius. Registered : Determine the number of sides of the inscribed polygon. Next, you define graphically or numerically the radius of the circle in which the polygon will be inscribed. ATTENTION : The number of ribs must be at least 3. Described: The way to use the command is the same as for the inscribed polygon.