11. FORMWORK

CHAPTER 11 'FORMWORK' 53 If you have activated the parameter , before defining the lines for placing the rebars, you must indicate a straight line to define the direction in which the rebar will be placed. The reinforcements are designed as single entities (blocks). Vertical post cut: Prerequisite : you must have edited the pole via the "Arming Details" command (it is sufficient to simply open the window). Then, on the xylotype, along with the detail of the pole, the vertical section of the pole will appear for the specific level. To display the total vertical intersection, select the command "Vertical intersection of pole", the pole and a point on the barrel (a small square will appear, which will be the insertion point). Weaponization: Prerequisite : you must have designed the reinforcement by "opening plates" between these options. Select the armature on which you want to draw the pattern and the following mask opens: Here, you define the length of the etching, either in meters, or as a function of F (multiple) You then choose whether to set one or two matches. In one etch, you have among the options of etching in the middle, either spacing from the beginning or end of the bar. In the two mates respectively, the options are in the thirds of the rod or at some of the distances from the ends.