11. FORMWORK

CHAPTER 11 'FORMWORK' 52 To place it, you point to the free end of the plate, select the semi-level to be placed by moving the mouse and set the point of its final placement. Armouring of a canopy support without continuity with another plate to the side of the support. To draw it, indicate in order the outer side of the beam, the inner side and finally the free end of the cantilever. Bendable reinforcement for supporting the cantilever with continuity with another plate on the side of its engagement. To place it, point first at the beam face, then at the free end of the cantilever. Flexible reinforcement for intermediate support of continuous slabs (four-strand, two- strand or a combination of both). For its placement you must indicate the two sides of the common support beam of the plates. New! Additional separation reinforcement. To install it, you indicate the two sides of the bearing beam starting from the outer one. : Enter the diameter of the reinforcement in the first field and the distance between the bars in the second field. ή : In the first field you give the number of bars and in the second field the diameter their. Mounting Angle : Select one of the default mounting angles for the reinforcement direction or type any angle in the corresponding field. The reinforcement address can also be specified graphically if you activate the option, in which case the program will ask you to indicate an existing straight line for specifying the address. Accepting all the above options is done by pressing the button or cancel by pressing the button. How to use : 1. You activate the command and set the parameters of the installed reinforcement. 2. Pressing the button closes the dialogue box and the program prompts you to define the lines for the placement of the reinforcement, depending on the type of reinforcement. 3. After you have set the last line, the armature is displayed on the screen and the program asks you to specify the point where it will be placed. The movement of the pointer on the screen is followed by the drawn armature until you indicate the positioning point with the left mouse button, at which point the armature is fixed there. Remark :