11. FORMWORK

CHAPTER 11 'FORMWORK' 51 2. In the dialogue box that opens, select the type of reinforcement by pressing with the mouse on the corresponding circle. 3. Enter the number of irons in the first field and their diameter in the second. 4. Depending on the type of , indicate the beams and/or the necessary points for its installation. The reinforcement is initially displayed on the screen, can moved parallel to the selected beams and is finally placed in the position you indicate with the mouse. The reinforcements are designed as single entities (blocks). Additions to Plate Supports: In the dialogue box that opens, you specify the data of the additional reinforcements for the plate support that you will install. Iron type : Here you can select the type of iron according to the topology of the plates. In particular : Straight-line reinforcement for intermediate support of continuous slabs (four-row, two-row or a combination thereof). For its placement you must indicate the two sides of the common support beam of the plates. Rectilinear reinforcement for supporting a cantilever with continuity with another plate on the side of its engagement. To position it, you should first point to the free end of the cantilever and then to one of the two sides of its supporting beam. Additional end plate support reinforcement or spalling reinforcement in amphibious slabs. To install it, point to the two sides of the bearing beam starting from the outer one. Additional reinforcement of the free end of the free end of headlamps or tripods.