11. FORMWORK

CHAPTER 11 'FORMWORK' 50 on the screen and is finally placed in the position you select by pressing the left mouse button. The reinforcements are designed as single entities (blocks). Beam Support Additives: With this command you place additional reinforcement for supporting beams on a tension or compression footing. In the dialogue box that opens, enter : Type of iron : Here you can select the type of iron according to the type of support, by pressing with the mouse on the corresponding icon. In particular : Common additional reinforcement in intermediate support of beams in tension or compression. For its placement, you must indicate the two beams involved in the common support and the final position to be drawn on the formwork. Straight additional reinforcement, intermediate or end-supported, for a beam, tension or compression. For positioning you first indicate the beam, a point the reinforcement will start (e.g. a top of the column where the beam rests) and the final position to be drawn on the formwork. Additional C-shaped reinforcement, intermediate or end support, for a beam, on its upper leg. For positioning you first indicate the beam, a point the reinforcement will start (e.g. a top of the column where the beam rests) and the final position to be drawn on the formwork. Additional C-shaped reinforcement, intermediate or end support, for a beam at its lower leg. For positioning you first indicate the beam, a point the reinforcement will start (e.g. a top of the column where the beam rests) and the final position to be drawn on the formwork. How to use 1. You activate the command "Lumber>> Reinforcements>> Beam Support Additions".