11. FORMWORK

CHAPTER 11 'FORMWORK' 48 Three-way slab without continuity with others in the direction of reinforcement placement. Indicate • the outer side of the bearing beam of the plate • the free end of the tricuspid (2 straight lines) Three-tiered slab with a continuation on the side of the seat with a projection. Set : • the free end of the sheepskin • the outer side of the bearing bracket • the free end of the tricuspid (3 straight lines) Distribution armament. Indicate the two reinforcement limits for each plate. Upper+ Lower bars (with hook). Indicate the two reinforcement limits for each plate. Individual top or bottom irons (with or without hook). Indicate the two reinforcement limits for each plate. On these reinforcements you can use the tool of etching . By pressing the button next to the indication "With offset bars", it is possible to separate the straight bars from the broken bars of the plates. : Enter the diameter of the reinforcement in the first field and the distance between the bars in the second field. When the reinforcement to be installed is a ribbed plate spacer, enter the values of the number of bars and their diameter respectively in the third and fourth boxes. Remark : At any one time you should only give values to one of two types of iron. If you give both, then the second one will prevail (ribbed plate intersection reinforcement). Mounting angle : Select one of the default mounting angles for the direction of the reinforcement or type any angle in the corresponding field. The reinforcement direction can also be specified graphically if you activate the in which case the program will ask you to indicate an existing straight line to determine the address. The acceptance of all the above options is done by pressing the button or cancelled by pressing the button.