10C. DIMENSIONING PART 3/4

CHAPTER 10C 'DIMENSIONING' 3 Chapter 10C : Sizing - Iron-Wall (part 3/4) The 10th Module is called "DISCUSSION" and includes the following groups of commands: ✓ Scenarios - GENERAL ✓ Beams ✓ Equitable Control ✓ Pillars ✓ Sandals ✓ Slabs-Mesh ✓ Iron ✓ Wooden ✓ Masonry BETTON ✓ Charts GENERAL After the completion of the model, the input of the loads, the execution of the analysis and the creation of the combinations, the "Dimensioning" of the structural elements of the design follows, where the adequacy check is performed, based on the regulation selected in the "Dimensioning scenario" and the reinforcement of the concrete elements is entered. With SCADA Pro you can dimension projects made of concrete, metal, wood, load-bearing masonry and a combination of these. The Sizing manual is divided into 4 parts: • Part 1/4 GENERAL REQUIREMENTS FOR ALL MATERIALS • Part 2/4 COMMANDS FOR BETTING • Part 3/4 COMMANDMENTS FOR RAIL AND WOOD • Part 4/4 REQUIREMENTS FOR WALLING