10C. DIMENSIONING PART 3/4

CHAPTER 10C 'DIMENSIONING' 14 shows the different cross-sections included in the "Metal Beams" layer. The same procedures described above can be followed in order to manually dimension the remaining cross-sections or see the results booklet and the investigation. • Activate the Capability Check surcharge and then select the command , to take into account the surcharges foreseen by the Eurocode for the Capability Check. 1.2 Bending control (Hot rolled) The use of this command is used to check for bending. That is, the checks are performed for each member belonging to the given layer: Limit State of Failure • Check for bending (lateral) buckling due to axial compressive force • Torsional buckling check due to bending moment. • Check for torsional bending due to the simultaneous presence of axial compressive force and bending moment. Limit State of Functionality • Member deformation control • Edge (node) movement control OBSERVATION: A prerequisite sizing is that you called and executed the corresponding combination file in the configuration dialog box Using the command, the following dialog box appears.