10C. DIMENSIONING PART 3/4

CHAPTER 10C 'DIMENSIONING' 10 If you choose the manual procedure, you have the option check which checks, for each hex, you want to perform. This will print in the issue for each hexadecade the reasons for the respective checks selected. Finally, in the "User" option you can set your own intensive sizes, in order for the program to dimension the specific cross-section. In the next dialog box: specific intensities have been given by the designer and the intensities calculated by the program from the analysis have been deactivated. OBSERVATION: In the new versions of SCADA Pro a new feature was added that was activated in the cross- section control of metallic cross-sections. Recall that the cross-section control was previously done at the layer level and at the level of each cross-section but only the worst member for each intensive size was controlled. Now the check is still done at layer level and for each cross-section but now each member is checked by activating the option at the bottom as shown in the next picture.