10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 91 5.2.2.2 Overall On page 3 h , the Memo is displayed that carries the characteristics according to the Position of the Surface to be loaded. This is the command with which you can carry out punching checks on all the poles included in the outline of the flat plate, automatically, using the parameters automatically obtained from program. The same parameters shall be used for the set of columns where the perforation test will be carried out. 5.2.2.3 Edit The Edit command allows you to modify parameters specified in the Selective or Overall check. Select the command and left-click on the node of the column to be edited and the window of the parameters you had originally set for the drilling check on the selected column opens automatically. You can make the modifications that and repeat the check using the Calculate command. 5.2.2.4 User Control The user is given the ability to test different data on different nodes for a visual overview of results. This is a "clipboard" that is not saved in the issue, but allows the user to run tests in order arrive at the desired solution. 5.2.4 Composite Plates (See User Manual "Composite Plates")