10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 76 But at the bottom where the border on the right is another support line (the 19) calculate another red area length (point 2) For this reason, the oblique boundary of the red area was obtained. But if we had entered two support lines, one for the upper part (with the boundary of the plate) and one for the lower part (border with support lines 17,18,19) the result is the following which is the correct one. In general, the above algorithm and based on the latest improvements, works on slabs with regular rectangular shapes and cannabolic column arrangement. In slabs with odd shapes, overlapping loading strips as well as gaps between them may result. Two support lines have now been formed, 28 and 32.