10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 32 2.1.2 Totes With this command, you specify the support conditions of the poles for performing the satisfactory inspection. By selecting the command and after pointing to the node or nodes of the poles that you want to change the support conditions, you complete the selection by pressing the right mouse button and the following dialog box appears: In the first section there is a list of addresses where you select the address of the executable control and then from the next list the designation of the node to perform the satisfactory control. ATTENTION: • Note that the option here only applies to walls . OBSERVATION: • Node marking is a procedure that if not performed by the user, the program will consider all nodes "Free" at both addresses, except for the packed nodes. • The parameters of the Iconic are defined in Parameters > Node Inherent (see Sizing General (part 1) &1.3.7 Node Inherent)