10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 26 If you select "Show only those that miss" then you will display the sizes that exceed the maximum allowed value of p. In the same way, the reinforcement rate ρ down, ρ down and the reinforcement rate ρ max (the maximum of ρ up and ρ down) is displayed. • Reason for overarmouring In the same way as indicated above you have the possibility to display the reasons for exceeding reinforcement above, below or the maximum of these two (max). you will get the following vector image, where the values are shown only in the items for the in which the armature overshoot ratios exceed 1.