10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 113 While when the fg= 500 then only the REQUIRED is entered in the formula and as a result the change of the armature does not affect the result. OBSERVATION: The results of the deformation test on the plates based on EC2, are automatically updated based on the subsequent modification of their reinforcement. Also in the printout of the results, the section showing the load of the section It now appears ONLY when a combination is set In the new version of the software, a new warning message has been added concerning the calculation of plate deformations. In particular, when there is no sufficiency, the symbol "l/d" appears on the corresponding plate.