10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 101 Add or remove a new arming area. Coordinate of the beginning of the reinforcement area with IOP or Steel plate. The value is automatically filled in based on the End value of the previous area. Coordinated end of the reinforcement area with IOP or Steel plate. The value must be less than the total length of the plate opening. Thickness per layer of IOP or Steel laminate. Number of layers of IOP or Steel laminate. IOP or Steel laminate strip width. IOP or Steel laminate strip spacing. Anchor length of left and right end of IOP or Steel laminate. ZONE 7 ZONE 7 refers to the ENTIRE section and this is where the checks and the printing of the results are done. The commands in ZONE 7 are as follows: Carrying out checks. Issue creation. Deletion of previous checks and issue. Confirm input data and exit aid window. Cancel input data and exit aid window.