10B. DIMENSIONING PART 2/4

CHAPTER 10B 'DIMENSIONING' 10 To take into account the bars from only one opening, left-click on the yellow and white lines representing the reinforcement of the opening below and above respectively, so as to obtain the shape shown in the side image In order to change the bar of the left opening up and down, you have to use the arrow to switch to that opening. OBSERVATION: The change must always be made for both the bottom support and top support irons. Finally, in the "Support Width" field you can enter a different support width in order to increase the anchorage length of the irons. This change is made after selecting the width you want to change while activating the typing field with the existing beam width as the default value. 1.1.5 Right key operation in Dimensioning The right button function over a building block has now been activated. By moving the mouse pointer over a structural element e.g. a beam and pressing the right key, the following menu of options appears: where you select the command you want to run instead of using the command from the sections in the module.