10A. DIMENSIONING PART 1/4

Right below you specify the type of element contained in the selected layer. The program automatically understands the type of element if it is vertical (Pillars) and all other elements are Beams. With the " Calculate " command the program consolidates the data of the specific layer based on the above mentioned. The next section deals with the definition and processing of stop levels. Interruption levels are levels that are boundaries of the beams and poles where you want the integration for either one or the other direction to be interrupted. • For poles, the stopping levels are horizontal levels defined by the altitude. • For beams, the stop planes are always vertical planes defined by two points. Predefined limits: • for the horizontal planes the horizontal planes are the foundation level and the upper last level (the last level). • and for the beams are the vertical limits of the girder. • The default limits are not shown in the table of cut-off levels.