10A. DIMENSIONING PART 1/4

1.3.5.2 For EUROCODE scenario The following controls are: The first section deals with soil quality. " Soil Quality Control" where by activating the checkboxes of the trends you can set your own limit values. In the options "stop." and "shtr." you enter the values of the allowable stress and fracture stress respectively. " Soil Failure " check where by activating the checkboxes of the controls you activate the "Data" button and the parameters for checking the bearing capacity of the soil. If you have a soil engineering study, enter the soil data. For the checks in " Bending-Shear-Deflection-Deflection ", check the checkbox and enter the limit for the maximum height of the pedestal. During the dimensioning process the program carries out the check without shear. If the initial height of the pedestal does not satisfy the check then the program continues testing until it reaches the height that satisfies the check. If this is greater than the set limit a permanent message appears informing that a finer perimeter is required. At Fields type the prices of coefficients that you used in the analysis. For the " Functionality " checksactivating the checkbox allows you to enter the limit of the δcr/l ratio to be taken into account in the differential settling check. 1.3.6 Armaments In the first field, "common" for all structural elements, you specify which bar diameters are to be used. From the list of diameters you add or remove the one you enter in with the help of the keys and respectively.