10A. DIMENSIONING PART 1/4

For the control in "Rotate" check the checkbox. The program assumes Vcd = 0 and calculates the clips. enables the designer to set his own price for the minimum reinforcement percentage. If a value is given then the program will take it into account as the minimum reinforcement, and if the field is left blank, the program will take the regulation value into account. 1.3.4.2.6 Node Control L/S Control Activate the checkbox in the "Node Control" to perform the check required in the CIP cases *. §5.5.2.3 & §5.5.2.3 §5.5.3.3 located within the Column Arming Details. The way to carry out the check is described in detail in the corresponding chapter of the user manual B. PENSION FITTING LEVELS.