10A. DIMENSIONING PART 1/4

1.3.4.2.3 Circumference For the control in "Circumference" In the new version the part of the tightening parameters has been changed in order to have a uniform logic in these parameters in both regulations (ECE-CEEC and EC). More specifically, a separation of selection of poles, walls for the control in tensioning was made. New logic is as follows: When the option is unchecked on either the poles or the walls, it is not checked in both regulations. When the selection of poles is checked, for EC8 the check is made only at the level required (for DCM only in the critical area at the foundation foot (ground floor foot)). For DCH it is required and done everywhere at all levels. For EAK-EKOS the check is not done anywhere because there is nv criterion from analysis and it is up to the user to decide where to do the check. When the poles have the option AND activated "Bypass Regulation" then the check is done wherever the user chooses regardless of the regulation requirement. Specifically for EAK-EKOS it is the option that must be activated when want to selectively tighten the items I want. When the selection of walls is checked, then the check is made where required which for both regulations are those walls that are included in the critical length of the building. When in in files AND the option is activated "Bypass Regulation" then the check is done wherever the user chooses regardless of the regulation requirement.