10A. DIMENSIONING PART 1/4

HALYVAS: When determining the strengths of Steel (main & fasteners) there is the additional presence of Optical Recognition . Selecting Visual Recognition opens the list of steel grades that you select and automatically fills Fym . All other values are automatically filled in and with the Update the Constants for the Existing Steel (main & fasteners) are calculated. 3 h revision of the EIA CIP For steel, the material safety factor γs now depends not only on the material data reliability level but also on the detail data reliability level. These two new options have therefore been introduced: The option Laboratory Values CANEPE 2022 was also introduced, where the cs is derived from a combination of the two SDSs and the option Absent Values CANEPE 2022 was also introduced where the requirement for steel is that the material SDS is satisfactory (rather than tolerable which was in the previous revision). Then and before the initial sizing, as in the new building, the corresponding option in the parameters must be "Existing". Then and as usual you adjust the reinforcements of the structural elements.