10A. DIMENSIONING PART 1/4

NEW! "Level of performance for the calculation of aid" Added the option to select the performance level, so that either by changing the method (inelastic - elastic), or by changing the level of performance, the reinforcements can be calculated en masse, without the need to change the reinforcement details of each reinforced member. To enable it you must check the checkbox Attention! option is for the elastic analysis, but in the elastic analysis the performance level is defined by the analysis parameters, in the CANOPE button. Therefore, in order for the level change to be done correctly in this case, it must first be changed from there, the analysis must be re-run, the new combinations must be saved and finally entered into the sizing. Then the recalculation can be done. 1.3.1.4 Active Sizing Material By selecting Active Sizing Material the strengths of the materials taken into account are the selected strengths in the Sizing parameters (either New or Existing). 1.3.1.5 Materials In the fields Plates, Beams, Columns, Sheets, at the top, there is the choice of the corresponding materials: