EXAMPLE 8. SIMULATION & SOLUTION FLAT PLATES

EXAMPLE 8 - FLAT PLATES 11 However, in addition to the central hole, there should also be holes in the position of the inner posts. These holes are automatically created by selecting the command (not in the case of circular sections) and their number is added to the value in brackets. OBSERVATION In circular sections the contour is a circle with the same starting and ending point. This creates an inability to find a contour. The solution for these cases is to draw 2 arcs at the boundaries of the circle and use the Hole command to manually define the round holes. At the end there will be 7 holes set The command is used to calculate the grid.