EXAMPLE 6. BUILDING VALUATION & REDESIGN STUDY

EXAMPLE 6: "STUDY FOR THE VALUATION AND REDESIGN OF A BUILDING ACCORDING TO THE CANC. 45 In the following, the procedure, parameters and results of the controls of the "Pre-test" scenario in SCADA Pro are analyzed. The CANEP requires that certain criteria be met in order for the flexible methods to be applied. ▪ For the Elastic Static Analysis it provides a set of criteria (including morphological regularity) of which have been implemented in the project and are presented in the form of controls, those of which contain quantitative quantities and could be implemented computationally. ▪ For the Elastic Dynamic Analysis the only criterion set by the CEFR is that the inadequacy index λ is less than or equal to 2.5 (λ ≤ 2.5) or for one or more of these λ > 2.5 and the building is morphologically normal. However, for both methods, it gives the possibility to apply the elastic methods, for valuation only, as long as the coefficient of the permanent loads γsd is increased by 0.15. 4.5.1d) Also, according to Chap. 5, and as far as elastic analysis, static or dynamic, is concerned, its application is only permitted for valuation purposes, irrespective of the validity of the conditions of application (see §§ 5.5.2.b and 5.6.1.b), if the cSd coefficients in this § 4.5.1 are increased by 0.15 (i.e. γSd,ελ.= γSd+ 0.15 ). In the analysis section, you can now define a preliminary analysis scenario (pre-check), either static or dynamic, which will be run with an elastic spectrum and will perform all the checks for the analysis selection criteria, based on what was mentioned above. A prerequisite for the execution of the preliminary analysis scenario is: ✓ the existence of armaments ; and ✓ the calculation of the corresponding strength moments . For the purposes of this provision b. Regardless of the validity of the conditions of the possibility see the comments of previous paragraph, but under the §5.5.2β. provided that there is no substantial damage, the dynamic elastic method may be used for the purposes of assessment (only). In this case the safety factors of the simulation cSd provided for in § 4.5.1 shall be increased by 0,15.